Take control of your Bovine Blaster pump without leaving the driver's seat. The Bovine Blaster Switch is designed for installation in UTVs and feed trucks and is sized to fit factory switch blanks found in Polaris’, Can-Am’s, John Deere’s, etc. This momentary switch only activates the pump while the button is pressed, helping prevent unintended operation. Wiring is required for installation. Please refer to the wiring diagram photo for complete installation details.
For safety and equipment protection, use a fused power supply with a fuse rated no higher than 20 amps.
Connect wiring to the switch terminals using appropriately sized spade connectors.
The switch output can be wired directly to the fogger trigger solenoid terminal or used to activate a relay, depending on your installation preference.
Take control of your Bovine Blaster pump without leaving the driver's seat. The Bovine Blaster Switch is designed for installation in UTVs and feed trucks and is sized to fit factory switch blanks found in Polaris’, Can-Am’s, John Deere’s, etc. This momentary switch only activates the pump while the button is pressed, helping prevent unintended operation. Wiring is required for installation. Please refer to the wiring diagram photo for complete installation details.
For safety and equipment protection, use a fused power supply with a fuse rated no higher than 20 amps.
Connect wiring to the switch terminals using appropriately sized spade connectors.
The switch output can be wired directly to the fogger trigger solenoid terminal or used to activate a relay, depending on your installation preference.
